Technologies services

Technical services
Homepage
/
Technologies services
/
Question and Solution
/
Question: Alarm not in automatic mode (IG-CU series)

Question: Alarm not in automatic mode (IG-CU series)

(Summary description)Problem Description: High water temperature pre-alarm solution: 1. Check whether the control switch is AUTO 2. Check whether the emergency stop button has been released and reset 3. Check whether the circuit switch is turned on (handle up) 4. Once the cause of the alarm is found, press the reset button to extinguish the fault

Question: Alarm not in automatic mode (IG-CU series)

(Summary description)Problem Description:
High water temperature pre-alarm
solution:
1. Check whether the control switch is AUTO
2. Check whether the emergency stop button has been released and reset
3. Check whether the circuit switch is turned on (handle up)
4. Once the cause of the alarm is found, press the reset button to extinguish the fault

Information

Problem Description:

High water temperature pre-alarm

solution:

1. Check whether the control switch is AUTO

2. Check whether the emergency stop button has been released and reset

3. Check whether the circuit switch is turned on (handle up)

4. Once the cause of the alarm is found, press the reset button to extinguish the fault

Previous: Question: Low battery voltage alarm (automatic series)
Next: None
Previous: Question: Low battery voltage alarm (automatic series)
Next: None

Copyright © 2009 300.cn All Rights Reserved

300.cn Beijing  闽ICP备09005104号-1